Noise Maker – Ring in the New Year!

As I mention in my Kitchen Towel Rack post: I printed the Party Noise Maker by Works by Solo on my Prusa i3 MK2 at 240%. I first saw this Party Noise Maker on a youtube video by Joel Telling.

Well I should play the lottery! Check this out!

I knew I was going to be cutting it close because the filament roll was getting low, but wow! I can’t believe I lucked out! I don’t have a filament sensor, so it would have been a failed print. I was in bed and using the Printoid app to view the print and I saw some orange behind the extruder, so I thought… ugh a failed print!?!? So I threw on my pajamas and ran down stairs to my surprise! hahaha I’m seriously going to buy a few lottery tickets today! haha

If you want to see all of the photos and timelapse video click this link:

Once I get showered and dressed, I’ll go outside and test out the noise maker!


Leave a Reply

Your email address will not be published. Required fields are marked *